IntegraRack® IR-15 BallastRack™ Solar Module Racking System
15° Fixed Solar Ground Mount System
This fixed 15° ground mount system is designed to withstand hurricane strength winds and offers the ideal sun angle for regions near the equator. The IR-15 is can be quickly adjusted from 15°-0° in the case of an impending hurricane, making it perfect for places like southern Texas, Florida and most tropical islands.
- Fixed 15° Sun Angle With 0° Hurricane Setting
- Dealer/Installer Discounts Available
- Start a New Row / Add One Panel to Existing IR-15 System
- 6x Faster Than Traditional Ground Mount Systems
- Capable of Racking Solar Modules of Any Size
- Lowest Cost Per kW
- No Concrete Footings, No Earth Augers, No Post Pounding Required
- Multiple Mounting Options
- High-Strength Engineering
- Aircraft Grade Aluminum and Stainless Steel
$104.99
- Fixed 15° Sun Angle With 0° Hurricane Setting
- Dealer/Installer Discounts Available
- 4 Pack Includes Four Frames to Rack Three Panels / Add Four Panels to Existing IR-15 System
- 6x Faster Than Traditional Ground Mount Systems
- Capable of Racking Solar Modules of Any Size
- Lowest Cost Per kW
- No Concrete Footings, No Earth Augers, No Post Pounding Required
- Multiple Mounting Options
- High-Strength Engineering
- Aircraft Grade Aluminum and Stainless Steel
$419.96
- Dealer/Installer Discounts Available
- Uses a fast-setting epoxy to adhere geotextile material to the BallastRack frames and earth fill over for a very strong and fast ballasted system.
- Kit incudes a 50 ft. roll of strong geotextile material, a strong epoxy with mixing nozzle, a ratchetting wrench, and everything needed to prep the frames.
- Provides easy mounting in locations where ground penetration is not possible, with incredible strength against high wind speeds.
- Capable of ballasting up to 13 BallastRack frames (based on 46″ wide panel).
$89.99
- Dealer/Installer Discounts Available
- With this installation method each BallastRack frame clamps to two AnchorSpikes with a two part epoxy to create a strong anchor.
- Kit includes a ratcheting wrench, 10 IR AnchorSpikes and a full two part epoxy kit to mount up to 5 frames almost anywhere.
- The IntegraRack AnchorSpikes allow for extremely fast and easy mounting with the added ability to level the system on the spikes themselves (not recommended for use in rocky soil or loose sand).
*SDS Hammer Drill recommended for install
$144.99
- Dealer/Installer Discounts Available
- With this installation method each BallastRack frame clamps to two AnchorSpikes with a two part epoxy to create a strong anchor.
- Kit includes a ratcheting wrench, 22 IR AnchorSpikes and a full two part epoxy kit to mount up to 11 frames almost anywhere.
- The IntegraRack AnchorSpikes allow for extremely fast and easy mounting with the added ability to level the system on the spikes themselves (not recommended for use in rocky soil or loose sand).
*SDS Hammer Drill recommended for install
$299.99
- Dealer/Installer Discounts Available
- Kit Includes a ratcheting wrench for mounting panels, 22 concrete lag bolts, 22 washers and 2 concrete drill bits for mounting frames up to 11 frames to almost any concrete surface.
- Perfect for mounting to pre-existing concrete pads/patios (on-site engineering may be required by county) or newly poured concrete slabs/footings.
