IntegraRack® IR-45ASA Adjustable Seasonal Angle BallastRack™ Solar Module Racking System

This seasonally adjustable rack frame is the premier ballasted ground mount system and allows a single person to quickly and easily adjust each panel independently while offering the same easy mounting as the other BallastRack products. With its seasonal adjustability, amazing strength, and an extra 7.5 inches of height off the ground, this system can be used anywhere in the world and ensure that you get the most output from your solar system all year round.

  • Seasonal Adjustability From 15°-45°
  • Dealer/Installer Discounts Available
  • Start a New Row / Add One Panel to Existing IR-45ASA System
  • 6x Faster Than Traditional Ground Mount Systems
  • Capable of Racking Very Large Solar Modules
  • Lowest Cost Per Watt
  • No Concrete Footings, No Earth Augers, No Post Pounding Required
  • Multiple Mounting Options
  • High-Strength Engineering
  • Aircraft Grade Aluminum and Stainless Steel

$189.99

BallastRack Mounting Kits

These mounting kits are not required, but do offer easy mounting solutions for any of the IntegraRack BallastRack frames listed above. Only one kit is needed per system and each one is capable of mounting a set number of BallastRack Frames. While these mounting kits are not required they allow IntegraRack’s BallastRack Frames to be mounted in places that other systems cannot, while also being much faster and easier than any other solar racking system on the market. Each BallastRack Mounting Kit includes one ratchet wrench that allows for fast and easy panel mounting. Please refer to IntegraRack’s Stamped Engineering & Datasheets to see which mounting option is best for you.

  • Dealer/Installer Discounts Available
  • Uses a fast-setting epoxy to adhere geotextile material to the BallastRack frames and earth fill over for a very strong and fast ballasted system.
  • Kit incudes a 50 ft. roll of strong geotextile material, a strong epoxy with mixing nozzle, a ratchetting wrench, and everything needed to prep the frames.
  • Provides easy mounting in locations where ground penetration is not possible, with incredible strength against high wind speeds.
  • Capable of ballasting up to 13 BallastRack frames (based on 46″ wide panel).

$89.99

  • Dealer/Installer Discounts Available
  • With this installation method each BallastRack frame clamps to two AnchorSpikes with a two part epoxy to create a strong anchor.
  • Kit includes a ratcheting wrench, 10 IR AnchorSpikes and a full two part epoxy kit to mount up to 5 frames almost anywhere.
  • The IntegraRack AnchorSpikes allow for extremely fast and easy mounting with the added ability to level the system on the spikes themselves (not recommended for use in rocky soil or loose sand).
*SDS Hammer Drill and 21 inch concrete drill bit are recommended for install

$144.99

  • Dealer/Installer Discounts Available
  • With this installation method each BallastRack frame clamps to two AnchorSpikes with a two part epoxy to create a strong anchor.
  • Kit includes a ratcheting wrench, 22 IR AnchorSpikes and a full two part epoxy kit to mount up to 11 frames almost anywhere.
  • The IntegraRack AnchorSpikes allow for extremely fast and easy mounting with the added ability to level the system on the spikes themselves (not recommended for use in rocky soil or loose sand).

*SDS Hammer Drill and 21 inch concrete drill bit are recommended for install

$299.99

  • Dealer/Installer Discounts Available
  • Kit Includes a ratcheting wrench for mounting panels, 22 concrete lag bolts, 22 washers and 2 concrete drill bits for mounting frames up to 11 frames to almost any concrete surface.
  • Perfect for mounting to pre-existing concrete pads/patios (on-site engineering may be required by county) or newly poured concrete slabs/footings.

$59.99

Dealer/Installer Discounts Available FREE shipping on all roof mount orders over $100
0
Your Cart